Windows 2000 display resolution
Tip: These instructions apply to both Windows® 2000 and
Windows® XP.
Setting the resolution of your Dicom Theater display
In order to set the resolution of your Dicom Theater display you must be logged in using an account with administrator privileges.
1.To set the resolution of your Dicom Theater display(s) right click on the desktop and select “Properties”.
2.Select the “Settings” tab.
3.Select the rectangle that represents the first Dicom Theater display attached to the BarcoMed 2MP2CP display controller you are working with.
NOTE: If you are using the VGA capabilities of your BarcoMed 2MP2CP display controller, the resolution for the first display may be set to a VGA resolution of “640 x 480” pixels with 16 colors and a default refresh rate. If your BarcoMed 2MP2CP controller is not running VGA, the display may not be enabled yet. To enable the display, check the “Extend my Windows desktop onto this monitor” checkbox, but do NOT click the “Apply” button at this time.
4.Select the “Adapter” tab and then click on the “List All Modes” button. Select the resolution and refresh rate that your Dicom Theater display supports from the dialog box and click “OK”.
5.Click “OK” on the bottom of the Adapter Control Panel. If the “OK” button on the bottom of the Adapter Control Panel is not visible, press the “TAB” key once and then press “CTRL”+“Enter” to select “OK”.
6.Click “OK” in the “Windows will now apply your new desktop settings” dialog box. Your Dicom Theater display should now synchronize and display the Windows desktop.
95