Display controller installation
figure 7 below). By default, VGA should be enabled, switch 1 on and switch 2 off. If you decide to use a separate VGA monitor as your boot monitor, you must disable the BarcoMed 2MP2CP’s on- board VGA capabilities by changing the switch settings to switch 1 off and switch 2 on.
Figure 7
In figure 7 above, the VGA capabilities of the BarcoMed 2MP2CP are enabled.
Caution: To use multiple BarcoMed 2MP2CP controllers in a single host with VGA enabled, you should enable VGA on only ONE of the BarcoMed 2MP2CP display controllers and disable VGA on ALL the other BarcoMed 2MP2CP display controllers.
Examples of PCI slots
The BarcoMed 2MP2CP display controller may be installed in either a
29