Barco MGP 15 Stopping and starting stabilization, Stopping stabilization manually, Introduction

Using Dicom Theater software

Stopping and starting stabilization

Introduction

Stabilization starts automatically after the projector was calibrated from MediCal Pro.

The stabilization process can be stopped and restarted explicitly by the user using the Dicom Theater application.

However, if the stabilization process terminates automatically, then the user cannot restart it again via the application. The user is required to go to MediCal Pro and activate the preset of her or his choice. This will re-activate the stabilization process.

E.g., in case the user switches inputs or presets by means of the projector’s remote control unit, stabilization will stop automatically. It can be re-started only by activating a preset in MediCal Pro.

Stopping stabilization manually

If for some reason you wish to stop the projector stabilization (e.g., in case there is too much ambient light), proceed as follows:

1.Position the cursor over the Dicom Theater sys-tray icon and click the right mouse button (“right-click”).

The Dicom Theater menu appears.

Figure 32

2.Click Stop Stabilizer.

The stabilization process will stop.

83