Source Set Up

Vertical refresh [sync/async] : The way of updating the image information on the LCD panels.

*For sources with a vertical frequency up to 60 Hz : the vertical refresh rate is the same as the vertical frequency of the incoming source. This is a necessity to project moving images without 'motion artefacts'. For stationary images with a vertical frequency up to 60 Hz it is still possible to use asynchronous refresh. When loading Pal, Secam, NTSC-files syncronous mode is default, for all other sources below 60 Hz asyncronous mode is default.

*For sources with a vertical frequency higher that 60 Hz : the vertical refresh is different than the vertical frequency of the incoming source. Synchronous refresh cannot be used.

Vertical sync polarity : Vertical refresh can be synchronised with the leading sync edge [arrow down] or trailing sync edge [arrow up].

Press EXIT to leave the Edit File Option menu.

Press EXIT to leave the Edit menu. A confirmation menu will be displayed (only when the file is opened as "Read/Write").

"Save changes to file "filename.ext" ? yes or no.

Use the control disk to select yes or no and press ENTER.

Rename

To change the name of a selected file to the name given in the TO area.

Use the control disk to select RENAME and press ENTER. The rename menu will be displayed.

Use the control disk to select a file name in the left part of the menu and press ENTER to select. This file name will be written in the FROM area and the TO area. The TO area is active.

Press ENTER to select the separate characters. Push the control disk to the right or to the left to select the desired character. Change that characters by pushing the control disk up or down. Numeric characters can be entered directly with numeric keys on the RCU. Press ENTER to select Ok.

Press ENTER for OK. The renamed file is entered in the list of files. Press EXIT to leave the Rename menu.

Copy

To copy a selected file to the file with the name and extension given in the TO area.

Use the control disk to select COPY and press ENTER. The copy menu will be displayed.

Use the control disk to select a file in the list of files in the left part of the menu and press ENTER to select. This file name will be written in the FROM area and the base name of the selected file in the TO area. The file index in the TO area will be an unused file index. The TO area becomes active. Press ENTER to select the separate characters. Push the control disk to the right or to the left to select the desired character. Change that character by pushing the control disk up or down (digits can be entered directly using the numeric keys). Press ENTER to select Ok.

Press ENTER for OK. The copied file is entered in the list of files. Press EXIT to leave the Copy menu (note : if the file index is changed to an existing index, a confirmation menu will be displayed).

FILE SERVICE

Load

Edit

Rename

Copy

Move

Delete

RENAME FILE

pal

.s1

From :

pal

.c50

......... c..

secam .s3

To

 

 

......... c..

pal

.c50

OK

 

 

852

FILE SERVICE

 

Load

 

 

Edit

 

 

Rename

 

 

Copy

 

 

Move

 

 

COPY FILE

 

pal

.s1

From :

pal

.c50

......... c..

secam .s3

To

 

 

......... c..

pal

.c50

OK

 

 

853

8-4

 

5975348 BARCOVISION 8200 210497

 

Page 34
Image 34
Barco R9001280 owner manual Rename, Copy