Bay Technical Associates V79 PDI-1, V80 PDI-2 owner manual Enable / Disable Time Tagging

5.1.4.4 HOST ADDRESS

By responding to the Enter Selection: message at the end of the Reporting Setup Menu on page 23 with "4" (Host Address), you may program the address of the designated host module. The designated host module is where event samples are sent when using Immediate or Schedule Reporting Method. The PDI will respond with the Host Address menu as follows:

HOST ADDRESS

Host Address 1:1,1

Enter Unit Number (1-32) <cr>, or X to EXIT:

Enter Module Number (1-16) <cr>, or X to EXIT:

Enter Port Number (1-4) <cr>, or X to EXIT:

Enter the appropriate Host Address. This consists of the Unit Number (1 to 32), Module Number (1 to 16), and Port Number (1 to 4) where the designated host module is located. Each entry should be followed by <ENTER>. If there is a single M Series unit in service, the Host Address would typically be Unit 1, Module 1, Port 1.

NOTE: The Host Address must be supplied to direct self-reporting event samples to the desired destination. If the Host Address is incorrect, self-reporting event samples will be misdirected or lost.

5.1.4.5 TIME TAG

By responding to the Enter Selection: message at the end of the Reporting Setup Menu on page 23 with "6" (Time Tag), you may program the PDI to append a time tag to the end of event samples automatically. The PDI will respond with the Enable/Disable Time Tagging menu as follows:

ENABLE / DISABLE TIME TAGGING

Time Tagging	DISABLED
Enable	1
Disable	2
Exit	X
Enter Selection:

27