Black Box ServSensor V4E Lite, EME144A-R2 manual Installation Setting Up the IP Address

Chapter 3: Installation

3. Installation

3.1 Setting Up the IP Address

The ServSensor V4E Lite is shipped with the default IP address of 192.168.0.100. Follow the steps listed below to change this IP address to fit your own network configuration.

Before starting, make sure you have these items:

•(1) RJ-45 male CAT5 crossover cable

•(1) PC with Ethernet card or LAN socket

•(1) Power socket for the unit to connect to

To set up the IP address:

1.Connect the ServSensor V4E Lite via its Ethernet port to your computer’s Ethernet port with a CAT5 crossover cable.

2.Open a Web browser and type the default IP address (as in Figure 3-1), then press the Enter key.

Figure 3-1. Google Web Browser screen.

NOTE: In some cases, your computer might not be able to connect to this default IP address. In this situation, you will need to change the IP address of your PC. See the instructions above.

3.After you press the Enter key in Step 2, Figure 3-2 appears. The default password for Admin is “public.” Change the password to make your unit secure.

Page 10 724-746-5500 blackbox.com EME144A-R2