Bosch Appliances D9412GV3 manual #CC#Scope, # Custom Function, # Door Point

D9412GV3/D7412GV3 Program Entry Guide 6.0 ACCESS CONTROL

EN 141

All SDI devices, regardless of area assigned, report to Area 1, Account 1 by default upon SDI failure. If a D9210B becomes disconnected, an SDI Fail ## and a Missing Point ### Event is created.

If the D9210B is not programmed with a D# Entry Area, 9210 NOT READY appears at the keypad with this door assigned to it when you press the [ENTER] key.

D#CC#Scope

Default:	0
Selection:	0 to 8
1 to 8	Determines disarming rights. The
	user’s access level and the CC #
	Scope determines which areas are
	disarmed.

0Only the area assigned to the D# Entry Area disarms this door.

Enter the keypad number (CC#) which determines the scope of the user ID’s disarming rights. Areas disarm on the basis of this keypad’s scope and the authority level of the user.

The D# CC# Scope prompt is limited to the first 8 keypads.

D# Custom Function

Default:	0 (Disabled)
Selection:	0, 128-143 (128-131 on the
	D7412GV3)
0	Custom function disabled.
128-143	The custom function number that
	executes upon a valid ID, given the
	appropriate user access level and
	area arm state.

You can program a custom function to run at the keypad programmed for CC# Scope. This custom function activates only for users with an L## Function Level? Assignment (refer to Section 2.10 User Interface on page 76) in which a valid ID can execute a custom function during the armed or disarmed state. The user number to which the token is assigned must have an assigned passcode.

If D# Disarm On Open is set to Yes for the same door, and L## Function Level? is set to D or C, the custom function executes when the door is physically opened.

A user’s access level and the armed state of the area determine whether the custom function activates. This access level is programmed in the L## Function Level? prompt. Refer to 2.10 User Interface on page 59.

Table 39 on page 141 shows how this programming affects custom function activation.

Table 39: Effects of Programming on Custom Function Activation

	L## Function	Custom Function Activation
	Level?
	M	User token activates the custom
	(Armed)	function assigned to the Door
		Controller only while the entry area
		for the Door Controller is Master
		Armed or Perimeter Armed.
	D	User token activates the custom
	(Disarmed)	function assigned to the Door
		Controller only while the entry area
		for the Door Controller is disarmed.
	C	User token activates the custom
	(Armed and	function assigned to the Door
	Disarmed)	Controller regardless of the armed
		state of the entry area.
-		User token does not run the custom
		function assigned to the Door
		Controller.

A user’s security level must have an M,

P, or D to operate the custom function.

D# Door Point

Default:	0
Selection:	0 to 127, 129 to 247(0 to 75 on the
	D7412GV3)
1 to 127,	The point number assigned to this
129 to 247	door. Points 128 and 248 are
	reserved by the control panel for
	internal use.

0No point number is assigned to this door.

Enter the point number assigned to this door. This point cannot be used for any other point assignments.

Bosch Security Systems, Inc. 10/11 F01U170807-02