Bosch Appliances D9412GV3 manual # Close Window Start, # Close Window Stop

D9412GV3/D7412GV3 Program Entry Guide 4.0 Schedules (Skeds)

EN 109

If the window must activate on the same day as it is programmed, reboot the control panel to activate the window immediately.

W# Close Window Start

Default:	00: 00
Selection:	HH:MM (hours and minutes)

Enter the time that you want the control panel to start the Closing Window. The window goes into effect at the beginning of the minute.

00:00 is midnight, 23:59 is 11:59 PM. Make entries using a 24-hour clock (for example, 7:00 AM is entered as 07:00, 2:45 PM is entered as 14:45).

This program item is one of three required to create a Closing Window. To program a Closing Window, Close Early Begin and Close Window Stop must also be programmed.

If the area is not armed when the Close Window Start time comes, a warning tone sounds and PLEASE CLOSE NOW appears at the keypad. To temporarily silence the tone, press the [ESC] key on the keypad. The warning tone restarts in 10 min if the area is not armed.

Refer to the W# Close Early Begin prompt in this section for explanations of report features.

W# Close Window Stop

Default:	00: 00
Selection:	HH:MM (hours and minutes)

Enter the time that you want the control panel to end the Closing Window. The window stops at the end of the minute.

00:00 is midnight, 23:59 is 11:59 PM. Make entries using a 24-hour clock (for example, 7:00 AM is entered as 07:00, 2:45 PM is entered as 14:45).

This program item is one of three required to create a Closing Window. To program a Closing Window, Close Early Begin and Close Window Start must also be programmed.

If the area is not armed by the time the Close Window Stop time expires, the control panel generates a Fail to Close Report if enabled in Fail To Close.

Closing Reports generated between the Close Window Start time and Close Window Stop time can be suppressed by programming Disable O/C in Window as Yes. Refer to the W# Close Early Begin prompt for other explanations of report features.

Do not use a time of 23:59 as a window stop time unless the window continues on the next day at 00:00. Fail to Close Reports are not sent, and the Auto Close feature does not work for windows that stop at 23:59.

Do not program a single window to cross the midnight boundary. The window stop time must be later than the window start time. To program a window that effectively crosses the midnight boundary, you must program two windows.

For example, to program windows for an area that closes between 11:30 PM and 12:30 AM, five days a week, use two windows as shown in Table 32.

Table 32: Programming Example: Linking Two Closing Windows over Midnight

W

#

1

2

Day of Week

S M T W T F S S M T W T F S

	Open			Close		eXcept
Early			Early			On
Begin	Start	Stop	Begin	Start	Stop	Holiday
			22 : 00	23 : 30	23 : 59	Yes	No
			00 : 00	00 : 00	00 : 30	Yes	No

	Holiday
	Index			Area(s)
1	2	3	4	1 2 3 4 5 6 7 8
1	2	3	4	1 2 3 4 5 6 7 8

Bosch Security Systems, Inc. 10/11 F01U170807-02