Bosch Appliances D9412GV3 manual CC# Enter Key Relay, CC# Enter Key Cycle Door, CC# Assign Door

D9412GV3/D7412GV3 Program Entry Guide 2.0 Panel and Area Wide Parameters

EN 53

CC# Enter Key Relay

Default:	0
Selection:	0 to 128, A, B, C (0 to 64, A, B, C
	for the D7412GV3)
0	The [ENTER] key is not used to
	activate a relay.
1 to 128 (64),	Assign the relay number that
A, B, C	activates when [ENTER] is pressed
	at this keypad after the user enters
	a valid passcode.

Enter Key Relay: Program the relay number that activates momentarily for 10 sec when a user enters a valid passcode and presses the [ENTER] key on the keypad. Two events are generated when this function is used: RELAY ### SET with User ID, and RELAY ### RESET without User ID. The system logs this action as two events.

Entering a valid code and pressing [ENTER] at a keypad silences a ringing bell.

Using CC# Enter Key Relay for a low-level access control strike on a door does not shunt a point.

When programmed to activate a relay, the [ENTER] key cannot be used for any other function.

Relays used for this function must not be shared with any other point, sensor reset, control panel, or bell functions. Sharing can cause errors in relay operation.

CC# Enter Key Cycle Door

Default:	No
Selection:	Yes or No
Yes	The [ENTER] key is used to cycle the
	door programmed for CC Assign
	Door.
No	The [ENTER] key is not used to cycle
	the door.

Enter Key Cycle Door: Program this prompt as Yes to start the door cycle sequence for the door number programmed in CC# Assign Door when a user enters a valid passcode and presses [ENTER]. This includes shunting the point assigned to the door. ACCESS GRANTED prints on the local printer and at the central station receiver, if programmed.

 The service passcode cannot be used for the CC# Enter Key Cycle Door application.

When programmed to activate a relay, the [ENTER] key cannot be used for any other function.

Relays used for this function must not be shared with any other point, sensor reset, control panel, or bell functions.

Sharing can cause errors in relay operation.

The door does not cycle if Enter Key Relay is programmed.

9210 NOT READY appears at this keypad when you press [ENTER] if the D9210B is not programmed with a D# Entry Area (in the Access Control section) or if CC Assign Door does not have a door number assigned.

CC# Assign Door

Default: No Door

Selection: No Door, 1 to 8 on D9412GV3.

	(No Door, 1, 2 on D7412GV3)
No	No door controller is assigned for adding
Door	tokens.
1 to 8	The door controller assigned to this keypad
	is used to read new tokens when the Add
	User Mode is initiated.

If the assigned door remains open and this keypad has the CC# Close Door Warning Tone set to Yes, the CLOSE DOOR # message appears on this keypad.

Bosch Security Systems, Inc. 10/11 F01U170807-02