Bosch Appliances D9412GV3 manual ## Swinger Bypass, ## Report Bypass at Occurrence, ## Cross Point

D9412GV3/D7412GV3 Program Entry Guide 3.0 Points

EN 99

P## Swinger Bypass

Default: No

Selection: Yes or No

Yes		Enable Swinger Bypass for this point.
No		Disable Swinger Bypass for this
		point.
	To meet UL requirements, set this
	parameter to No.

Use the P## Swinger Bypass parameter to allow the control panel to bypass automatically a point that reports two or more alarm or trouble events within the same arm cycle. The maximum number of faults allowed on a point is set in the Swinger Count prompt (refer to page 138).

The control panel reports a Swinger Bypass when the Swinger Count is reached and P## Report Bypass at Occurrence is set to Yes. If the point has a partial count (less than the Swinger Count number of events during an hour), the count is reset to zero.

P## Bypassable does not need to be programmed as Yes for swinger bypass to work.

A Swinger Shunted point returns to the system if P## Bypass Returnable? is Yes. If not, return the point to the system through manual unbypass or [COMMAND][0][0]. Refer to P## Bypass Returnable in the program entry guide for additional information.

P## Report Bypass at Occurrence

Default:	No
Selection:	Yes or No
Yes	Send a Command Bypass Report
	when the point is bypassed.
No	Do not send a Command Bypass
	Report when the point is bypassed.

Send a Command Bypass Report as soon as a user bypasses the point from the keypad. Enable this option for all Bypassable 24-hour points. You can also report a bypassed point at the time the area is armed. Refer to P## Defer Bypass Report on page 99.

P## Defer Bypass Report

Default:	No
Selection:	Yes or No
Yes	Send a Point Bypass Report with the
	Closing Report instead of a
	Command Bypass Report when a
	user bypasses the point.
No	Do not defer Bypass Reports.

Use this option to prevent P## Type (0 to F) points that are bypassed by the user (COMMAND BYPASS) from occurring until the area is armed. When the area is armed, the bypassed points and any point being bypassed during the arming sequence report as POINT BYPASS along with the Closing Report.

When P## Defer Bypass Report is set to Yes and Closing Reports are suppressed by using Closing Windows, the deferred Bypass Reports are not sent.

Bypass Reports for 24-hour points do not report If P## Report Bypass at Occurrence and P## Defer Bypass Report are both set to No.

To report the bypass at occurrence and when the area is armed, program P## Report Bypass at Occurrence and P## Defer Bypass Report as Yes. A Command Bypass Report is sent as soon as the user manually bypasses a point, and a supplemental Point Bypass Report is sent with the Closing Report.

P## Cross Point

Default:	No
Selection:	Yes or No
Yes	This point is a Cross Point.
No	This point is not a Cross Point.

Do not use Cross points for Fire points.

The P## Cross Point option is designed to reduce false alarms. To achieve this, program two or more points within a Cross Point Group with this prompt enabled. The Cross point feature is available only on points where P## Pt Response is set to a value that generates an instant alarm response.

Bosch Security Systems, Inc. 10/11 F01U170807-02