Bosch Appliances D9412GV3 manual ## Bypass Returnable, ## Bypassable, A# Auto Close prompt

D9412GV3/D7412GV3 Program Entry Guide 3.0 Points

EN 98

P## Bypass Returnable

Default:	No
Selection:	Yes or No
Yes	This point automatically returns to
	the system when the area is
	disarmed.
No	This point stays out of the system
	through arming and disarming
	cycles.

Use this option to return a point that was bypassed, force armed, or swinger bypassed back into the system when the area to which this point is assigned is disarmed. This option applies to all point types.

Set this item to No for Interlock points.

When the point cannot return to the system through disarming, the point must be manually unbypassed using the Unbypass?, keypad function, Sked Functions 4 and 5, or remote programming software (RPS).

For Force Armed points to remain bypassed, ensure that P## Force Arm Returnable is set to No.

P## Bypassable

Default:	No
Selection:	Yes or No
Yes	This point can be bypassed and
	force armed.
No	This point cannot be bypassed or
	force armed from the keypad or
	remote programming software
	(RPS); however, it can be force
	armed by automatic arming at the
	end of the Closing Window (refer to
	the A# Auto Close prompt in
	Section 2.8.4 Open/Close Options
	on page 43 or by a Sked
	programmed to arm the area.

To meet UL 864 requirements, set this parameter to No.

Use this option to allow this point to be bypassed or force armed.

Bypassing a 24-hour point: When a 24-hour point or 24-hour Supervisory point is bypassed, 24 HOUR BYPASS scrolls continuously at the keypad.

Bypassing a Fire Point: FIRE BYPASS scrolls to indicate that a 24-hour Fire point or a Fire Supervisory point is bypassed.

Alternative to a 24-hour Point: For alarm capability of a 24-hour point without the continuous scrolling, use a Perimeter point with a Point Response of 9 to E.

If the P## Bypassable option is set to Yes, a point can be bypassed in several ways. Refer to Table 27.

Table 27: Bypassing a Point

Bypass with:	Report sent:
Keypad using the Bypass?	Command Bypass
function
Keypad using Command 0	Command Bypass
Sked Function 3	Sked Bypass
Remote programming software	RPS Bypass1
(RPS)

1RPS Bypass is sent at the end of the RPS session.

If the P## Swinger Bypass option is set to Yes, a point is automatically bypassed after the fourth alarm or trouble report is sent. A swinger Bypass report is sent at the same time.

Programming Bypassable as Yes for Cross Points can cause missed Cross- Point alarms. For example, if Points 1 and 2 were programmed as Cross Points and Point 1 was Bypassed or Force Armed, Point 2 cannot generate an Alarm Cross Point Event. Point 2 can; however, generate an Unverified or Alarm Event depending on how the point was faulted. Be careful when using this feature with Cross Point applications.

Bosch Security Systems, Inc. 10/11 F01U170807-02