Bosch Appliances D9412GV3 manual CC# Scope, CC# A1 through A# in Scope, Same A# Account Number

D9412GV3/D7412GV3 Program Entry Guide 2.0 Panel and Area Wide Parameters

EN 52

CC# Scope

Default:	Refer to the program record sheet
Selection:	Panel Wide, Custom, No Keypad,
	Area, and Account
Panel	A panel-wide keypad can view
Wide	information and perform Arming and
	Disarming functions for all areas in
	the control panel. A panel-wide
	keypad can cross account
	boundaries. This is normally used
	with a master area.
Account	An Account keypad can view
	information, and perform Arming and
	Disarming functions for all areas with
	the same A# Account Number, in
	Area Parameters. This is normally
	used for an associate area.
Area	An area keypad is restricted to
	viewing information and Arming or
	Disarming functions for the area to
	which it is assigned.
Custom	A custom keypad shows information
	and allows arming and disarming for
	specific areas you select. (This option
	is not available through Keypad
	Programming.)
No	No keypad installed at this address.
Keypad	CALL FOR SERVICE display shows,
	indicating the control panel is not
	polling this address.

This program item is used to define the areas affected when an arming command is executed on this keypad, the areas this keypad can view, and the areas to which this keypad can move.

In applications where keypads include more than one area, active alarms in remote areas must be acknowledged before arming or disarming the local area.

The following prompt is visible only when you program CC## Scope to Custom. If you change the keypad scope selection to Custom from Panel Wide, Account, or Area, the settings from the previous CC# Scope selection become the default settings for the custom parameters in CC# A1 [through A#] in Scope. Before exiting from a custom program, check each area and ensure that it is enabled and disabled correctly.

CC# A1 [through A#] in Scope

Default:		Refer to the preceding important
Selection:		note
		Yes or No
Yes	Include this area in the scope of this
		keypad.
No	Do not include this area in the scope
		of this keypad.

Determines whether any of the areas and doors are included in the scope of this keypad for viewing status, arming or disarming, and controlling doors from the keypad.

Keypad Programming of CC# Scope

D1255

1.Refer to Figure 1 on page 7 to access Keypad Programming and navigate to the COMMAND CENTER option.

2.Press [ENT]. The CC NUM 1 – 16 option shows.

3.Enter the keypad number you wish to configure and press [ENT]. The keypad reads CC# SCOPE, and then the current configuration (for example, PANEL WIDE).

4.To change the configuration, press [ENT] when the current configuration shows, and then press [NEXT] or [PREV] to scroll through the options, as listed in CC# Scope on page 52 .

5.When the keypad reads the desired configuration option, press [ENT] to select it.

When the keypad reads PARAMETER SAVED, your selection has been configured.

D1260

1.Refer to Figure 2 on page 8 to access Keypad Programming and navigate to the Command Center option.

2.Press [ENTER]. The CC Num 1 – 16 option shows.

3.Enter the keypad number you wish to configure and press [ENT]. The keypad reads CC# Scope, and then the current configuration (for example, Panel Wide).

4.To change the configuration, press the Edit softkey, and then press the Next or Previous sofkeys to scroll through the options, as listed in CC# Scope on page 52 .

5.When the keypad reads the desired configuration option, Save to select it.

When the keypad reads Parameter Saved, your selection has been configured.

Bosch Security Systems, Inc. 10/11 F01U170807-02