Bosch Appliances D9412GV3 manual ## View Memory, ## View Point Status, ## Walk Test, ## Fire Test

D9412GV3/D7412GV3 Program Entry Guide 2.0 Panel and Area Wide Parameters

EN 69

L## View Memory

Default:	Refer to the program record sheet
Selection:	- or E
Function	Function Name	Alternate
No.		Keystroke
9	View Event	[COMMAND][4][0]
	Memory

View all memory events that occurred since the last time the system was armed for all areas within the scope of the keypad in this area.

L## View Point Status

Default:	Refer to the program record sheet
Selection:	- or E
Function	Function Name	Alternate
No.		Keystroke
10	View Point Status	(Menu function
		only)

View the current status of all points in the area to which this keypad is assigned.

L## Walk Test

Default:	Refer to the program record sheet
Selection:	- or E
Function	Function Name	Alternate
No.		Keystroke
11	Walk Test	[COMMAND][4][4]

Walk Test all Interior or Perimeter Controlled points in the area to which this keypad is assigned.

The following features come with the Walk Test Mode:

Battery powered control panel only. A Battery Test runs during the whole test to ensure that the battery capacity is capable of supporting the full load of the control panel if AC fails.

-This test includes 2-sec Bell Test when the Walk Test starts.

-The test ends when all points are tested or the test times out after 20 min of no activity.

Local alarm annunciation and event printing; no reports are sent to the central station receiver.

D1255 Keypad displays a sequential count, and text after each point is activated and restored.

The keypad displays ALL PTS TESTED and an All Points Tested Event is sent to the central station receiver (if programmed) when the last point is tested.

If enabled in Routing, Walk Start and Walk End Reports are sent to the central station receiver at the beginning and end of the test.

To Walk Test a Door point connected to a D9210B Access Interface Module, open the door without activating the door sequence or allowing it to time out past the extended shunt time.

L## Fire Test

Default:	Refer to the program record sheet
Selection:	- or E
	Function Name
Function		Alternate
No.		Keystroke
12	Fire Test	[COMMAND][5][8]

Fire Walk Test all 24-hour points in the area where this keypad is assigned.

One person can perform a Fire Walk Test without assistance. The following features come with the Fire Test Mode:

Battery powered control panel only. A Battery Test runs during the whole test to ensure that the battery capacity is capable of supporting the full load of the control panel if AC fails.

-This test includes a 2-sec Bell Test (Fire Bell relay) for each Fire point that is tested.

-The test ends when all points are tested or the test times out after 20 min of no activity.

Local alarm annunciation and event printing; no reports are sent to the central station receiver.

Automatic smoke detectors reset for all Fire points programmed with P## Resettable as Yes.

D1255 Keypad displays a sequential count and the text for the point after each point is activated and restored.

If enabled in Routing, Walk Start and Walk End Reports are sent to the central station receiver at the beginning and end of the test.

A# Verify Time for Fire points that is programmed with Yes for P## Alarm Verify is ignored during the Fire Walk Test.

Bosch Security Systems, Inc. 10/11 F01U170807-02