MIC400 Series Camera Installation and Operation Manual
Installation Instructions
WARNING: Electrical Danger: Ensure all power is disconnected before opening or working upon any Power Supply Unit.
Installation must be carried out by suitably qualified persons & all local safety regulations should be followed. After removal of the lid take care as components can reach a temperature of 55 Deg C.
CAUTION: It is extremely important to observe the correct polarity, failure to do so will result in the destruction of the
CAUTION: This power supply was designed for negative earthed vehicles only it is not suitable for use with positive earth vehicles.
To install the
1.Locate the mounting position of the
2.Securely fix the
3.Feed all cabling through the appropriate sized gland holes.
4.Connect the composite cable to HD3 following the colour coding as shown in the Table B & printed on the PCB, connect all wires.
5.Connect the Brown and Grey wires for the IR lamps to HD6 as per Table J
6.Connect the Coaxial video cable to the CN1 header.
EN 26
7.If alarms are to be used connect these to HD2 as per Table I above.
8.Telemetry connections are provided by headers HD4 and HD5 which respectively enable crimp or screw terminations for connecting the MIC400 to the control equipment.
9.Connect the power to HD1 carefully observing the polarity and voltage as per Table A.
10.A washer drive is provided on this power supply, a mains rated relay is fitted and
11.Once connected the washer drive can be tested using the red SW1 which should activate the pump. When pressed the LED, (LED3) next to the washer switch should illuminate. The LED will also illuminate in response to telemetry commands to switch the washer on. The Red LED on the washer PCB will illuminate when the Washer function is selected at the control room end. Note that the software in the camera prevents the washer from being run more than 10 seconds continuously. (This is to prevent the washer bottle from being inadvertently emptied. The red button on the washer drive card can be used to both test the washer operation and to prime the washer pump.
12.When wiring is complete, apply power & check the all six (6) LED’s are lit.
13.LED1 and LED2 when light show that 15v AC is available from the power supply (i.e. the supply fuses are intact. There is no indication of the operation of the Telemetry lines as this would increase the load on these lines reducing the number of cameras that can be driven by a single telemetry spur.
14.LED 3 illuminates when the washer drive relay is selected to on.
15.LED 4 monitors the internally generated +5v rail used to drive the alarm interface circuits around HD2. This +5v supply is not available externally.
Bosch Security Systems | Issue 1 |
