Bosch Appliances X10 manual Malfunction, Possible causes, Recommended solution

VideoJet X10Appendix en 105

Malfunction	Possible causes	Recommended solution
The unit does not report	Alarm source is not selected.	Select possible alarm sources on
an alarm.		the Alarm Inputs configuration
		page.
	No alarm response specified.	Specify the desired alarm
		response on the Alarm
		Connections configuration page,
		change the IP address if
		necessary.
Control of cameras or	The cable connection between	Check all cable connections and
other units is not	the serial interface and the	ensure all plugs are properly
possible.	connected unit is not correct.	fitted.
	The interface parameters do not	Make sure that the settings of all
	match those of the other unit	units involved are compatible.
	connected.
The unit is not	Power failure during	Have the unit checked by
operational after a	programming by firmware file.	Customer Service and replace if
firmware upload.		necessary.
	Incorrect firmware file.	Enter the IP address of the unit
		followed by /main.htm in your
		Web browser and repeat the
		upload.
Placeholder with a red	JVM not installed on your	Install Sun JVM from the
cross instead of the	computer or not activated.	product CD.
ActiveX components.
Web browser contains	Active proxy server in network.	Create a rule in the local
empty fields.		computer's proxy settings to
		exclude local IP addresses.

Bosch Security Systems Installation and Operating Manual DOC V4.0 2009.06