Bosch Appliances X10 5.40, Advanced Mode Multicasting, SNMP host address / 2. SNMP host address

Models: X10

1 124
Download 124 pages 61 Kb
Page 81
Image 81
1. SNMP host address / 2. SNMP host address

VideoJet X10

Configuration Using a Web Browser en 81

 

 

If you select On for the SNMP parameter and do not enter an SNMP host address, the VideoJet X10 does not send them automatically, but only replies to SNMP requests. If you enter one or two SNMP host addresses, SNMP traps are sent automatically. Select Off to deactivate the SNMP function.

1. SNMP host address / 2. SNMP host address

If you wish to send SNMP traps automatically, enter the IP addresses of one or two required target units here.

SNMP traps

You can select which traps are to be sent.

1.Click Select. A list is opened.

2.Click the checkboxes to select the required traps. All the checked traps will be sent.

3.Click Set to accept the selection.

Authentication

If a RADIUS server is employed in the network for managing access rights, authentication must be activated here to allow communication with the unit. The RADIUS server must also contain the corresponding data.

To configure the unit, you must connect the VideoJet X10 directly to a computer using a network cable. This is because communication via the network is not enabled until the Identity and Password parameters have been set and successfully authenticated.

Identity

Enter the name that the RADIUS server is to use for identifying the VideoJet X10.

Password

Enter the password that is stored in the RADIUS server.

RTSP port

If necessary, select a different port for the exchange of the RTSP data from the list. The standard RTSP port is 554. Select Off to deactivate the RTSP function.

5.40

Advanced Mode: Multicasting

In addition to a 1:1 connection between an encoder and a single receiver (unicast), the VideoJet X10 can enable multiple receivers to receive the video signal from an encoder simultaneously. The device either duplicates the data stream itself and then distributes it to multiple receivers (Multi-unicast) or it sends a single data stream to the network, where the data stream is simultaneously distributed to multiple receivers in a defined group (Multicast).

Bosch Security Systems

Installation and Operating Manual

DOC V4.0 2009.06

Page 81
Image 81
Bosch Appliances X10 5.40, Advanced Mode Multicasting, SNMP host address / 2. SNMP host address, SNMP traps, Identity