BM 2610014415
| general Safety Rules |
| “READ ALL INSTRUCTIONS” Failure to follow the safety rules listed below and other basic |
! WARNING | |
| safety precautions may result in serious personal injury. |
|
Work Area
KEEp CHIldREN AWAy
Do not let visitors contact tool or extension cord. All visitors should be kept away from work area.
KEEp WORK AREAS ClEAN
Cluttered areas and benches invite accidents.
MAKE WORKSHOp
With padlocks, master switches.
AVOId dANgEROUS ENVIRONMENTS
Don’t use power tools in damp or wet locations. Keep work area well lit. Do not expose power tools to rain. Do not use tool in presence of flammable liquids or gases.
personal Safety
KNOW yOUR pOWER TOOl
Read and understand the owner’s manual and labels affixed to the tool. Learn its application and limitations as well as the specific potential hazards peculiar to this tool.
dON’T OVERREACH
Keep proper footing and balance at all times.
Stay alert. Watch what you are doing. Use common sense. Do not operate tool when you are tired. Do not operate while under medication or while using al- cohol or other drug.
dRESS pROpERly
Do not wear loose clothing or jewelry. They can be caught in moving parts. Rubber gloves and
USE SAfETy gOgglES
Also face or dust mask if cutting operation is dusty, and ear plugs during extended periods of operation.
gUARd AgAINST ElECTRIC SHOCK
Prevent body contact with grounded surfaces. For example: pipes, radiators, ranges, refrigerator enclo- sures.
dISCONNECT TOOl fROM pOWER SOURCE When not in use, before servicing, when changing blades, bits, cutters, etc.
KEEp gUARdS IN plACE
In working order, and in proper adjustment and align- ment.
REMOVE AdjUSTINg KEyS ANd WRENCHES
When not in use, before servicing, when changing blades, bits, cutters, etc.
AVOId ACCIdENTAl STARTINg
Make sure the switch is in the “OFF” position before plugging in tool.
NEVER STANd ON TOOl OR ITS STANd Serious injury could occur if the tool is tipped or if the cutting tool is accidentally contacted. Do not store materials on or near the tool such that it is necessary to stand on the tool or its stand to reach them.
CHECK dAMAgEd pARTS
Before further use of the tool, a guard or other part that is damaged should be carefully checked to en- sure that it will operate properly and perform its in- tended function. Check for alignment of moving parts, mounting and any other conditions that may affect its operation. A guard or other part that is dam- aged should be properly replaced.
All repairs, electrical or mechanical, ! WARNING should be attempted only by
trained repairmen. Contact the nearest Bosch Factory Service Center, Authorized Service Station or other competent repair service.
|
| Use only Bosch replacement parts; | |
! | WARNING | ||
any others may create a hazard. | |||
|
| ||
|
| Use only accessories that are rec- | |
! | WARNING | ||
|
| ommended by the manufacturer for | |
|
|
your model. Accessories that may be suitable for one tool, may become hazardous when used on an- other tool.
Tool Use
dON’T fORCE TOOl
It will do the job better and safer at the rate for which it was designed.
USE THE RIgHT TOOl
Don’t force small tool or attachment to do the job of a
SECURE WORK
Use clamps or a vise to hold work. It’s safer than using your hand and it frees both hands to operate the tool.
“SAVE THESE INSTRUCTIONS”
