Bosch Power Tools GTS1031 manual Tools Needed for Assembly And Adjustment, THICK. this Edge

BM 2610014415 01-11 E:BM 2610012089 12-10 E 1/10/11 7:17 AM Page 8

lEAdINg ENd

The end of the workpiece which, during a rip type operation, is pushed into the cutting tool first.

MOldINg

A non-through cut which produces a special shape in the workpiece used for joining or decoration.

NON THRU-SAWINg

Any cutting operation where the blade does not ex- tend through the workpiece (e.g. Dado, Rabbet).

pUSH STICK

A device used to feed the workpiece through the saw during narrow ripping-type operation and helps keep the operator’s hands well away from the blade. Use the Push Stick for rip widths less than 6 inches and more than 2 inches.

pUSH blOCK

A device used for ripping-type operations too narrow to allow use of a Push Stick. Use a Push Block for rip widths less than 2 inches.

RAbbET

A notch in the edge of a workpiece. Also called an edge dado.

RIppINg

A cutting operation along the length of the workpiece cutting the workpiece to width.

REVOlUTIONS pER MINUTE (R.p.M.)

The number of turns completed by a spinning object in one minute.

Tools Needed for Assembly And Adjustment

COMBINATION SQUARE MUST BE TRUE

			STRAIGHT EDGE OF BOARD
			3/4" THICK. THIS EDGE
		DRAW LIGHT LINE ON	MUST BE PERFECTLY
HEX “L” WRENCH	PHILLIPS SCREWDRIVER		STRAIGHT.
(Supplied-Insert Plate)		BOARD ALONG THIS EDGE.

2 MM

		SHOULD BE NO GAP OR OVERLAP
COMBINATION SQUARE	HEX “L” WRENCH	HERE WHEN SQUARE IS FLIPPED
	(Supplied-Tool Adjustment)	OVER IN DOTTED POSITION.
	5 MM

! WARNING	Disconnect plug from power source before performing any assembly, adjustment or repair
	to avoid possible injury.

-8-