BM 2610014415
FIG. 59
! | WARNING | All repairs, electrical or mechani- | |
cal, should be attempted only by | |||
|
trained repairmen. Contact the nearest Factory Service Center or Authorized Service Station or other competent repair service. Use only identical replacement parts, any other may create a hazard.
lUbRICATION | FIG. 60 |
The gear case has been completely lubricated at the factory. However, after six months to one year, de- pending upon use, it’s wise to return your tool to the nearest Service Center for the following:
• Brushes replaced.
• Parts cleaned and inspected.
• Relubricated with fresh lubricant.
• Electrical system tested.
• All repairs.
The following parts should be oiled occasionally with
SAE No. 20 or No. 30 oil, or WD 40 (Fig. 60).
1. Elevation, support rods, and gears.
2. Sliding rails and supports.
3. Table locking cams (Front & Rear).
2 | 3 | 1 |
Recommended Accessories
Item | Cat. No. | Item | Cat. No. |
Dust bag | TS1004 | Pusher Guide System | TS1010 |
Zero Clearance Insert | TS1012 | Table Saw Stand | GTA500 |
Dado Insert Set | TS1013 |
|
|
!WARNING
Use only recommended accessories. Follow instructions that accompany accessories. Use of improper accessories may cause hazards.
