Bosch Power Tools GTS1031 manual BlAdE bEVEl CONTROl, EXTENdINg TAblE Extension

BM 2610014415 01-11 E:BM 2610012089 12-10 E 1/10/11 7:17 AM Page 24

blAdE bEVEl CONTROl

Loosen blade bevel lock handle 1 counterclockwise (Fig. 35), slide the elevation wheel 2 until pointer 3 is at desired angle and tighten blade tilt lock handle

1clockwise.

FIG. 35

4 3 1 2

EXTENdINg TAblE EXTENSION

To extend the table, raise the table extension lock handle 4 (Fig. 35) and slide table extension 5 to de- sired width (Fig 35a). To secure table setting, lower the lock handle 4.

FIG. 35a

5

USINg THE RIp fENCE pOINTER	the locking lever, will hang off the rail. The maximum
WHEN TAblE IS NOT EXTENdEd	cutting capacity to the right of the blade when the
The rip fence pointer shows the distance from the	extension table is fully extended is 18”. To achieve
blade to rip fence through a convenient viewing.	this capacity, a portion of the fence glide pads, lo-
Align rip fence pointer 4 with lower portion of scale	cated underneath the locking lever, will hang off the
	rail. In either case the rip fence pointer should never
5. The lower scale can be used for widths up to 10
	be positioned beyond 10” on the lower scale for
inches (Fig. 36).
	maximum cutting capacity (Fig. 37).

USINg THE TAblE pOINTER
WHEN TAblE IS EXTENdEd	FIG. 37
The upper portion of scale 6 is used for rip cut 10 to	BODY OF FENCE
18 inches. Align table pointer 7 with upper portion of
scale 6 (Fig. 36).
NOTE: The maximum cutting capacity to the right of
the blade when the extension table is closed is 10”,
as noted on the scale. To achieve this capacity, a	EDGE OF TABLE
portion of the fence glide pads, located underneath

FIG. 36	7		11
		4

6

5

-24-