Boss Audio Systems GT-6B owner manual Playing Sounds, Making Connections

Chapter 1 Playing Sounds

Making Connections

*To prevent malfunction and/or damage to speakers or other devices, always turn down the volume, and turn off the power on all devices before making any connections.

*Raise the amp volume only after turning on the power to all connected devices.

*When using mono output, connect the cable only to the OUTPUT L (MONO) jack.

*Use only specified expression pedals (optional Roland EV-5 or Roland FV-300L and PCS-33). Use of other manufacturer’s products may

result in damage to the unit.

fig.01-01

Bass Guitar

AC Adaptor

StereoBRC-series

Headphones

Bass Amp

Mixer

EV-5 FV-300L etc.

FS-5U FS-5L etc.

*To prevent the disruption of power to your unit (should the plug be pulled out accidentally), and to avoid applying undue stress to the AC adaptor jack, anchor the power cord using the

cord hook, as shown in the illustration.

fig.01-02

*The pin assignment for the OUTPUT (XLR) connector connectors is as shown below. Before making any connections, make sure that this pin assignment is compatible with that of

all your other devices.

fig.01-50

1: GND

2: HOT

3: COLD

For more on how to use the OUTPUT (XLR) connectors, refer to p. 55

*When using the unit with an expression pedal connected to the SUB EXP PEDAL/SUB CTL 1,2 jack, set Minimum Volume of an expression pedal to the “MIN” position.

12