Chapter 2 Creating You Own Favorite Tones (Patches)
Changing the Order of the Effects (Effect Chain)
You can freely change the order in which the effects are
connected. |
| |
|
| 2 |
|
| 2 |
| 3 | 1 |
1. | Press [NAME/NS/MASTER] until “Effect Chain” | |
appears in the display.
*Each time [NAME/NS/MASTER] is pressed, the item that can be set is changed, following this order:
Name → Noise Suppressor → Master → Bypass EXP Mode- → Foot Volume → Effect Chain.
* Effects are shown in lowercase letters when turned off.
2.Use the VALUE dial or PARAMETER [ 
] [ 
] to move the cursor to the point where you want to have
the effect inserted.
3.Press the ON/OFF button for the effect you want to insert.
The selected effect is inserted at the cursor position.
*You cannot directly switch placement of the noise suppressor in the order of effects. However, you can change the placement indirectly by changing the order of other effects placed before and after the noise suppressor.
*Use [PEDAL ASSIGN] to assign Foot Volume.
4.If you want to change the sequence further, repeat Steps 2 and 3.
5.If you want to save the sequence you’ve set up, use the Write procedure (p. 23) to save it to a User patch.
Press [EXIT] to return to the Play screen.
You can switch effects on and off even while making the settings for the connection order. You can use the ON/ OFF buttons corresponding to the effects appearing to the left and right of the cursor to turn these effects on and off.
22
