Boss Audio Systems GT-6B owner manual Using Sound On Sound, Procedure, Number 4 pedal Stop, Erase

Chapter 7 Using Sound On Sound

You can use the “Sound On Sound function” by selecting “SOS” with the REV/DLY Fx Select (p. 27).

Here, the Number 4 pedal and the BYPASS/CTL pedal automatically function as Sound On Sound controls.

fig.07-01

Number 4 pedal: Stop, Erase

CTL pedal: Record, Play, Overdub

*The Number 4 pedal won’t function as the Sound On Sound control pedal if the Patch Select mode (p. 60) has been set to the Bank/Number method of selection.

The available recording time in “HiQlty” mode (in which priority is placed on sound quality) is approximately 3 seconds, and approximately 6 seconds in “LongTime” mode (in which priority is placed on longer recording time).

Procedure

fig.07-02
1. Confirm that the CTL pedal’s red	Blink
indicator is flashing.
This means that the GT-6B is in
recording standby mode and that
there is nothing in the memory.
Additionally, the rate at which the

indicator flashes indicates the

tempo, allowing you to use this as a quick tempo check during recording.

*Depress the Number 4 pedal at least twice while “Tempo” (p. 29) is set to “BPM,” and the tempo is set to match the timing

you'’ve used while depressing the pedal (tap input).

fig.07-03
2. Press the CTL pedal to begin	Lit
recording.

The CTL pedal’s red indicator stops flashing and stays lit, indicating that the GT-6B is recording.

* Recording stops automatically as soon as the amount that's been recorded exceeds the available recording time.

3.Press the CTL pedal to end the recording. When you stop recording, the recorded phrases simultaneously starts playing back. The CTL pedal’s red indicator light goes out, and the green indicator flashes, indicating that playback is in progress.

In addition, the Number 4 pedal’s indicator lights up,

indicating that the memory contains recorded data.

fig.07-04

Lit Dark Blink

fig.07-05
4. Press the CTL pedal once again to	Lit Blink
begin overdubbing.

Synchronize the overdub to the recorded phrase.

The CTL pedal’s green indicator flashes and the red indicator light

goes on, indicating that playback

and recording are being carried out simultaneously.

Each time the CTL pedal is pressed, playback and overdubbing repeat.

5.When you have finished playback and overdubbing,

press the Number 4 pedal.

fig.07-06
6. If you want to erase the results of	Dark
your recording, press and hold
down the Number 4 pedal for at
least two seconds.

*The recorded content is temporary. Note that carrying out the following procedures erases the recording.

•Turning off the power to the GT-6B.

•Switching to another patch

•Setting the REV/DLY Fx Select to anything other than “SOS.”

•Switch for SOSMode

*For more information about each of the “SOS” parameters, refer to p. 29.

54