50
Chapter 5 Setting the Pedal Functions (Pedal Assign)

When controlling an On/Off target with the

expression pedal

fig.05-15
* The range that can be selected changes according to the target
setting.
* When the “minimum” is set to a higher value than the
“maximum,” the change in the parameter is reversed.
* The values of settings may change if the target is altered after
the “minimum value” and “maximum value” are set. Be sure
to check the “minimum value” and “maximum value” settings
after changing the target.
Source
fig.05-16
This sets the controller (source) that affects the target
parameter. Controllers that can be selected as the source are
shown below.
•EXP PEDAL Expression pedal
•EXP SW Expression pedal switch
•CTL PEDAL CTL pedal
* The CTL pedal indicator is not lit. The indicator lights up
according to the CTL pedal setting (p. 46).
•SUB EXP PEDAL
External expression pedal connected to the SUB EXP
PEDAL/SUB CTL 1, 2 jack.
* Set SYS: Sub CTL 1 Func (p. 63) to “Assignable.”
•SUB CTL 1, 2
Foot switch connected to the SUB EXP PEDAL/SUB CTL
1, 2 jack.
* Set SYS: Sub CTL 1, 2 Func (p. 63) to “Assignable.”
•MIDI CC# 1–31, 64–95
Control Change messages from an external MIDI device
(1–31, 64–95).
* The CTL pedal indicator lights according to the settings made
with the CTL pedal.
Source Mode
fig.05-17
This determines the manner in which the setting is to be
changed when a momentary-type foot switch (such as the
optional FS-5U) is used.
* The GT-6B’s control pedal is a momentary-type pedal. Switch
the settings as needed to accommodate your setup.

Normal

The normal state is Off (minimum value), with the switch On
(maximum value) only while the foot switch is depressed.

Toggle

The setting alternately switches between On (maximum
value) and Off (minimum value) with each press of the foot
switch.

Example (1)

When switching effects on and off with a foot switch

Example (2)

When the effect is applied more, or is on only while the
foot switch is being pressed
OFF
On
Target Max
Off
Target Min
When the pedal
is fully advanced
When the pedal
is fully raised When the pedal
is advanced halfway
Expression Pedal
ON
Source Source Mode
Momentary-Type
CTL pedal
FS-5U (external)
Toggle
Latch Type
FS-5L (external) Normal
Expression pedal
EV-5 (external) Normal
Source Source Mode
Momentary-Type
CTL pedal
FS-5U (external)
Normal
Latch Type
FS-5L (external) cannot function
Expression pedal
EV-5 (external) Normal