Installing the device in a rack or cabinet

2

Remove the rack mount kit from the shipping carton. The kit contains the following:

Two L-shaped mounting brackets.

Four rack mount rails: two for side attach and two for rear attach racks.

Thirty-two 8-32 x 5/16 in., panhead Phillips screws with patchlocks.

Eight 10-32 x 5/8 in., panhead Phillips screws (torque to 25 in-lb, 29 cm-kg). See item 1 in Figure 10.

Eight 32-10 retainer nuts (for square-hole rack rails). See item 2 in Figure 10.

Eight 32-10 retainer nuts (for round-hole rack rails) See item 3 in Figure 10.

FIGURE 10 4-post screws and retainer nuts

1

2

3

Use the following steps to mount devices in a 4-post rack.

CAUTION

Do not use the hardware supplied in a 2-post rack mounting kit to mount a Brocade ICX 6650 device in a 4-post rack. Mounting the device in a 4-post rack requires additional hardware to prevent drooping from possible flexing and distortion of the 4-post rack when a device is not properly installed.

1.Attach the mounting brackets to the sides of the device as illustrated in Figure 8 above using the 8-32 x 5/16 in. screws.

2.Attach the appropriate rails: either side attach or rear attach at determined by the type of rack in which you are installing the device.

Figure 11 and Figure 12 show exploded views of the optional 4-post rack mount kit.

Brocade ICX 6650 Hardware Installation Guide

15

53-1002599-01

 

Page 31
Image 31
Brocade Communications Systems 53-1002599-01 manual Show exploded views of the optional 4-post rack mount kit