Brocade Communications Systems 53-1002599-01 Power supply specifications, General specifications

Power supply specifications A

Power supply specifications

All units ship with two RPS15 redundant, load sharing, and hot swappable power supplies.The power supplies are universal and capable of functioning worldwide without voltage jumpers or switches. They meet IEC 61000-4-5 surge voltage requirements and are autoranging in terms of accommodating input voltages and line frequencies.

Table 6 lists the power state definitions for the Brocade ICX 6650.

TABLE 5	Power state definitions
Power State	Definition
Idle	All ports down, no optics or cables connected.
Typical	56x10 GbE, 4x40 GbE, and 4x4x10 GbE ports linked
	and UP. 10% traffic with 64-byte packets. Fans at normal
	speed.
Maximum	All ports connected with optics to draw maximum power
	per MSA Optics Specification. Traffic at full rate or 100%
	throughput. Fans at full speed.

Table 6 lists the power supply specifications for the Brocade ICX 6650.

TABLE 6	System power specifications
AC Voltage	Input Watts	BTU’s/hr	Power State
120 VAC	114.6	391.14	Idle
120 VAC	154.6	527.66	Typical
120 VAC	230	785.01	Maximum

Inrush current should be limited to 35A peak for any initial current surge or spike of 10ms or less at either cold or warm start. Any additional inrush current surges or spikes in the form of AC cycles or multiple AC cycles greater than 10ms and less than 150ms must not exceed 25A peak. After 150ms the AC input current will be less than the rating of input fuses and the other components within the power supply.

General specifications

Table 7 lists the general specifications for the Brocade ICX 6650.

TABLE 7	General specifications
Specification		Description
System architecture		Nonblocking shared-memory switch
System processor		800 MHz PowerPC
Switch bandwidth		1600 Gbps
Forwarding bandwidth (data rate, full		1190 Mpps
duplex)

Brocade ICX 6650 Hardware Installation Guide	49
53-1002599-01