5 Replacing fan trays
CAUTION
Disassembling any part of the power supply and fan assembly voids the warranty and regulatory certifications. There are no
Determining the need to replace a fan assembly
Enter the show chassis command in the command line interface to display fan status.
Time and items required
Replacing a fan assembly in the Brocade ICX 6650 should take less than two minutes to complete. You need the following items to replace a fan assembly in the Brocade ICX 6650 switch:
•A new fan assembly (must have the same part number and the same airflow label as the fan assembly being replaced; refer to Figure 18 on page 41 for the location of the airflow label)
•A #1 Phillips screwdriver
Replacing the fan assembly
Complete the following steps to replace a fan assembly in a Brocade ICX 6650 switch.
1.Using the Phillips screwdriver, unscrew the captive screw on the fan assembly.
2.Before opening the package that contains the new fan tray, touch the bag to the switch casing to discharge any potential static electricity. It is recommended that you wear an ESD wrist strap during installation.
3.Remove the fan tray from the
4.Ensure that the replacement fan assembly has the same part number and airflow label as the fan assembly being replaced.
5.Remove the fan assembly from the chassis by pulling the handle on the fan assembly out and away from the chassis.
6.Holding the fan tray level, guide it into the carrier rails on each side and gently push it all the way into the slot, ensuring that it firmly engages with the connector.
7.When you are sure the fan tray has properly engaged the connector, tighten the retainer screws to secure the fan tray in the slot.
CAUTION
Do not force the installation. If the fan assembly does not slide in easily, ensure that it is correctly oriented before continuing.
NOTE
The fans are controlled automatically by the device.
44 | Brocade ICX 6650 Hardware Installation Guide |
|
