26 Brocade ICX 6650 Hardware Installation Guide
53-1002599-01
Connecting network devices
3
Deleting an IP address
Enter a command similar to the following to delete an IP address.
Brocade(config-if-1/1/1)# no ip address 1.1.2.1
This command deletes IP address 1.1.2.1. You do not need to enter the subnet mask.
To delete all IP addresses from an interface, enter the followi ng command:
Brocade(config-if-1/1/1)# no ip address *
Syntax: no ip address ip-addr | *
Connecting network devicesBrocade devices support connections to other vendors’ routers, switches, and hubs, as well other
Brocade devices.
Connectors
For port pinouts, refer to “Pinouts and signalling” on page50.
Connecting a network device to a fiber port
For direct attachment from the device to a Gbps NIC, switch, or router, using a fiber optic
transceiver, you will need fiber cabling with an LC connector.
For information about transceivers supported on ICX 6650 devices, refer to the following Brocade
website:
http://www.myBrocade.com/downloads/documents/data_sheets/product_data_sheets/Optics_
DS.pdf
To connect the device to another network device using a fiber port, you must do the following tasks:
•Install a fiber optic transceiver (SFP, or SFP+)
•Cable the fiber optic transceiver
The following sections describe these tasks.