Memory: At least 32 MB
USB port (installed as standard equipment)
CD-ROM drive
Installing the P-touch Editor 3.2 software
The P-touch Editor 3.2 software includes a variety of more complex functions for printing bar- codes and images, enabling you to design just about any label that you can image. Install the P-touch Editor 3.2 software onto a Macintosh as described below.
To install the P-touch Editor 3.2 software
With a Mac OS before OS X:
1With the P-touch and the Macintosh turned off, connect the P-touch to the computer using the enclosed USB interface cable as described on page 10. Be sure to leave the P-touch turned off.
2Turn on the Macintosh.
3Insert the enclosed CD-ROM into the com- puter’s CD-ROM drive.
4Double-click the Mac OS 9 folder to open it.
5Double-click the P-touch Editor 3.2 folder to open it.
Ch. 2 Getting Started
6Double-click the P-touch Editor 3.2 Installer icon in the folder that appears. The installer starts up.
7Select the installation method.
●For a basic installation
Clicking the Install button immediately starts installing all options.
NOTE
About 20 MB of available hard-disk space is needed to begin installation. In order to install all options, about 100 MB of available hard-disk space is needed. If enough hard-disk space is available, click the Install button.
●For a custom installation
Clicking the Custom Install button dis- plays a dialog box that allows you to select which options to install.
Only the options with a check mark beside them are installed. Select the options that you wish to install, and then click the Install button.
NOTE
☞In order to print from the P-touch 9600/3600, “PT-9600/3600 Driver” must be selected for installation.
☞If certain options are not installed, some P- touch Editor functions may not be available.
