Brother 3600, 9600 Width function (WIDTH), To change the setting for the Width func- tion:

NOTE

☞Since the text sizes that can be printed depends on the width of the tape, the following table shows the maximum text size that can be used with each tape width.

The following text sizes do not apply to text with a Text rotation setting applied.

Tape width	Maximum text size
	(in points)
6 mm	12
9 mm	20
12 mm	28
18 mm	40
24 mm	64
36 mm	76

☞With the AUTO setting selected and the text in a block consisting of just one line of only upper- case letters (and no accented letters) and written horizontally/vertically without the BERMUDA font, the text is printed slightly larger than the maximum possible.

☞If the 4 point or 5 point text size setting is selected, the text will be printed with the BRUS- SELS font setting, regardless of the font setting that is selected.

To change the setting for the Size function:

1Select GLOBAL FORMAT, BLOCK FOR- MAT or LINE FORMAT (OR hold down d and press 1, 2or 3) as described on pages 52 to 53.

NOTE

This step may be skipped if settings for several format functions are being applied at the same time.

2Rotate r until SIZE is displayed, and then press r (OR press j or k until SIZE is displayed). The setting for the text at the cursor’s current position is shown on the left side of the display and a sample can be seen on the right side.

R123456789 ABCDEFK
R
RG 02/13
RH NO SIZE
L				Q
RI M AUTO
RJ AUTO	0.4	HELSINKI	A	AUTO
Length	Margin	Font	Width	Size

Ch. 3 Functions

3Rotate r (OR press m or g) until the desired setting is displayed.

NOTE

☞If “*****” appears as a setting, the Size function has already been applied to either a line in the current text block (if the Block format or the Global format function is being set) or a block in the current text (if the Global format function is being set). Changing the setting will cancel the setting that was previously applied.

☞To return the function to its default setting (AUTO), press the space bar.

☞To return to the text without changing the for- matting, press e (OR hold down d and press 1, 2or 3).

4Press r(OR press n) to apply the setting.

NOTE

If ris used to select the settings, only one function can be set at a time. To apply several format settings at the same time, press jor kto select the function, and then press m or g to select the desired setting. Press n only after the necessary functions have been set.

Width function (WIDTH)

The Width function can be used with any of the text sizes to make the size of the characters wider or more narrow. For samples of the available Width settings, refer to page 100. The width of the text at the cursor’s current position is shown at the bottom of the display.

R123456789 ABCDEFK
R
RHG ON <<< P-touch >>>
R	L				Q
RI M
	1:_
RJ AUTO		0.4	HELSINKI	A	AUTO
	Length	Margin	Font	Width	Size

To change the setting for the Width func- tion:

1Select GLOBAL FORMAT, BLOCK FOR- MAT or LINE FORMAT (OR hold down dand press 1, 2or 3) as described on pages 52 to 53.

Functions

55