DIFFICULTY | SUGGESTIONS |
PhotoCapture Center™ Difficulties | |
Removable Disk does not | a)Have you installed the Windows® 2000 update? |
work properly. | If not, do the following: |
| 1. Disconnect the USB cable. |
| 2. Install the Windows® 2000 update. Please see the Quick Setup |
| Guide. After the installation the PC will be automatically restarted. |
| 3. Wait about 1 minute after you reboot the PC, and then connect the |
| USB cable. |
| b)Take out the media card and put it back in again. |
| c) If you have tried "Eject" from within Windows®, you must take out the |
| media card before you continue. |
| d)If an error message appears when you try to eject the media card, it |
| means the card is being accessed. |
| Wait a while and then try again. |
| e)If all of the above do not work, please turn off your PC and MFC, and |
| then turn them on again. |
| (You will have to unplug the power cord of the MFC to turn it off.) |
|
|
Cannot access Removable | Make sure you have inserted the media card into the media slot. |
Disk from Desktop icon. |
|
|
|
Network Difficulties |
|
|
|
I cannot print over the Network | Make sure that your MFC is powered on and is On Line and in Ready |
| mode. Print Network Configuration list. (See Printing reports on page |
| |
| LAN cable to the hub to verify that the cabling and network connections |
| are good. If possible, try connecting the MFC to a different port on your |
| hub using a different cable. If the connections are good, the machine |
| shows LAN Active for 2 seconds. |
|
|
11 - 13 TROUBLESHOOTING AND ROUTINE MAINTENANCE