Brother MFC-5840CN manual 84

Remote commands

Follow the commands below to access features when you are away from the MFC. When you call the MFC and enter your Remote Access Code (3 digits followed by ), the system will give two short beeps and you must enter a remote command.

Remote commands			Operation details
95	Change the Fax
	Forwarding, Paging or Fax
	Storage settings
	1	OFF	You can select Off after you have retrieved
			or erased all your messages.
	2	Fax Forwarding	If you hear one long beep, the change has
			been accepted. If you hear three short beeps,
	3	Paging
			you cannot change it because something has
	4	Fax Forwarding number
			not been set up (for example, perhaps a Fax
	6	Fax Storage	Forwarding or Paging number had not been
			registered). You can register your Fax
			Forwarding number by entering 4. (See
			Changing your Fax Forwarding number on
			page 6-7.) Once you have registered the
			number, Fax Forwarding will work.
			You can select Off after you have retrieved
			or erased all your messages.
96	Retrieve a fax
	2	Retrieve all faxes	Enter the number of a remote fax machine to
			receive stored fax message(s). (See page
			6-7.)
	3	Erase faxes from the	If you hear one long beep, fax messages
	memory		have been erased from the memory.
97 Check the receiving status
	1	Fax	You can check whether your MFC has
			received any faxes. If yes, you will hear one
			long beep. If no, you will hear three short
			beeps.
98 Change the Receive Mode
	1	External TAD	If you hear one long beep, you can change
			the Receive Mode.
	2	Fax/Tel
	3	Fax Only
90	Exit		Press 90 to exit Remote Retrieval. Wait for
			the long beep, then replace the handset.

REMOTE FAX OPTIONS 6 - 6