Brother MFC-7300C manual Remote Commands Operation Details

Remote Commands

Follow the commands below to access features remotely. When you call the MFC and enter your Remote Retrieval Access Code (1 5 9 ), the system will signal you with two short beeps to enter a remote command.

	Remote Commands			Operation Details
95		Changing Fax Forwarding
		/Paging setting
		1	OFF	If you hear one long beep, the change is accepted. If you hear three
				short beeps, you cannot change it because the conditions have not
		2	Fax Forwarding
				been met (Example: registering paging number). You can register
		3	Paging	your fax forwarding number by using 4. FAX FWD NO. (see page
				9-6). Once you have registered the number, the MFC will change
		4	FAX FWD No.
				automatically to FAXFWD:ON mode. Then retrieve a Memory
				Status List by entering 961 (see page 9-5) to make sure that the
				Fax Forwarding number you registered is correct in the List.
		6	Fax Storage ON	You can turn FAX STORAGE to ON or OFF.
		7	Fax Storage OFF
96		Retrieve a fax
		1	Memory Status List	Enter the number of a remote fax machine to receive the Memory
				Status List or stored fax message(s). (See page 9-5.)
		2	Retrieve all faxes
		3	Erase fax from the memory	If you hear one long beep, you can erase fax message(s) from the
				memory.
97		Check the Receiving Status
		1	FAX	You can check whether your MFC has received any faxes . If yes,
				you will hear one long beep. If no, you will hear three short beeps.
98		Change Receive Mode
		1	TAD	If you hear one long beep, you can change the Receive Mode.
				If you hear three short beeps, you cannot change it.
		2	FAX/TEL
		3	FAX
90		Exit		After a long beep, you can exit remote retrieval.

R E M O T E F A X O P T I O N S ( N O T A V A I L A B L E F O R C O L O R F A X ) 9 - 4