Brother MFC 7300C owner manual Setting the Speaker Volume, Setting the Ring Volume

Setting Volume Amplify

Please carefully read Choosing the Handset Volume, page 5-4before you do the following steps:

1Press Function, 1, 1, 4.

2If none of the users are hearing-impaired,

press or to select VOL	VOL AMPLIFY:ON?
AMPLIFY:OFF? and press Set, then	SELECT <- ->& SET
go to Step 4—OR—If some or all of the

users are hearing-impaired, select VOL AMPLIFY:ON? and press Set.

3If all the users are hearing-impaired,

press or to select PERMANENT? and press Set— OR— If only some of the users are hearing- impaired, select TEMPORARY? and press Set.

4Press Stop to exit.

PERMANENT? SELECT <- ->& SET

TEMPORARY? SELECT <- ->& SET

Setting the Speaker Volume

You can adjust the speaker volume when your machine is onhook (after the machine is onhook dialing). You can turn the speaker off or you can select a speaker volume level. The default setting is the lowest volume.

Press or to adjust the volume level. The display shows the setting you are choosing. Each key press changes the volume to the next setting. The new setting will remain until you change it again.

Setting the Ring Volume

You can adjust the ring volume when your MFC is idle. You can turn the ring OFF or you can select a ring volume level.

Press or to adjust the volume level. With each key press, the MFC rings so you can hear the current setting and the display shows the setting you are choosing. Each key press changes the volume to the next setting. The new setting will remain until you change it again.

Memory Storage

In the event of a power failure, all settings in the INITIAL SETUP, SETUP RECEIVE, SET AUTO DIAL, REMOTE FAX OPT, plus the COVERPG SETUP and COVERPAGE MSG functions (from SETUP SEND) are stored permanently. You may have to reset the date and time.

I N I T I A L S E T U P 5 - 5