Brother MFC 7300C Special Line Considerations, Outgoing Message OGM, Roll Over Phone Lines

Outgoing Message (OGM)

Timing is important in recording this message.

1Record 5 seconds of silence at the beginning of your message. (This allows your MFC time to listen for the fax CNG tones of automatic transmissions before they stop.)

2Limit your speaking to 20 seconds.

3End your 20-second message by giving your Fax Receive Code for people sending manual faxes. For example:

“After the beep, leave a message or send a fax by pressing 51 and press Start.”

Special Line Considerations

Roll Over Phone Lines

A roll over phone system is a group of two or more separate telephone lines that pass incoming calls each other if they are busy. The calls are usually passed down or “rolled over” to the next available phone line in a preset order.

Your MFC can work in a roll over system as long as it is the last number in the sequence, so the call cannot roll away. Do not put the MFC on any of the other numbers; when the other lines are busy and a second fax call would be received, the fax call is transferred to a line that does not have a fax machine. Your MFC will work best on a dedicated line.

Two-Line Phone System

A two-line phone system is nothing more than two separate phone numbers on the same wall outlet. The two phone numbers can be on separate jacks (RJ11) or combined into one jack (RJ14). Your MFC must be plugged into an RJ11 jack. RJ11 and RJ14 jacks may be equal in size and appearance and both may contain four wires (black, red, green, yellow). To test the type of jack, plug in a two-line phone and see if it can access both lines. If it can, you must separate the line for your MFC. (See Easy Receive, page 6-3.)

2 - 12 A S S E M B L Y A N D C O N N E C T I O N S