Brother PC-2800 Bobbin Winding / Bobbin Thread Setting, 324,9, Spool cap 2 Spool 3 Spool pin

BOBBIN WINDING / BOBBIN THREAD SETTING

Winding the bobbin and setting the bobbin thread

CAUTION

Use only bobbins recommended by the manufacturer of this machine (see page 5). Using other bobbins may result in damage or injury.

324,9

5

6

7,8

1

CONTENTS

BEFORE USE

SEWING

3
	1	2
3		1

2

1.Connect the machine to the power supply and turn on the main power.

2.Place the spool of thread on the spool pin. The thread end should come from the bottom front of the spool. The spool cap closest to the thread spool size should be used to hold the spool securely on the spool pin.

1Spool cap

2 Spool

3 Spool pin

*The spool cap should be pushed on as far as it will go.

CAUTION

•If the thread spool and/or spool cap are set incorrectly, the thread may tangle on the spool pin and cause the needle to break.

•Use the spool cap (large or small) that is closest in size to the thread spool. If a spool cap smaller than the thread spool is used, the thread may become caught in the slit on the edge the spool and cause the needle to break.

Note

If using a fine thread such as cross wound thread, slightly sepa- rate the spool cap (small) from the spool of thread before using it.

1Cross wound thread

2 Spool cap (small)

3 Gap

PATTERNS UTILITY STITCHES MAINTENANCESEWING CHART(PROGRAMMED IN MACHINE)

10