Brother PC-2800 operation manual Presser Foot, Changing the presser foot, Presser foot holder

PRESSER FOOT

Changing the presser foot

CAUTION

•Always turn off the power before changing the presser foot. If the power is on and the “Start/ Stop” button or another button is pressed, the machine will start and may cause injury.

•Always use the correct presser foot for the selected stitch pattern. If the wrong presser foot is used, the needle may strike the presser foot and bend or break, and may cause injury.

•Only use presser feet for this machine. Using other presser feet may lead to accident or injury.

1.Press the “NEEDLE POSITION” button to raise the needle, and then turn off the power.

2.Raise the presser foot lever.

CONTENTS

BEFORE USE

SEWING

1

1 2

3.Press the black button at the back of the presser foot holder, and remove the presser foot.

1Presser foot holder

4.Place the presser foot pin directly below the holder-end and lower the presser foot lever to attach the presser foot.

1Holder-end

2 Foot pin

UTILITY STITCHES MAINTENANCESEWING

Removing the presser foot holder (while cleaning, etc.)

CHART

5

6

1

Use the included disc-shaped screwdriver to loosen the screw of the presser foot holder, and remove the presser foot holder.

Note

When reattaching the presser foot holder, first attach the presser foot to the presser foot holder. Then, lower the presser foot lever, install the presser foot holder and securely tighten the presser foot holder screw. The thread tension may be inaccurate if the presser foot holder is incorrectly attached.

1Disc-shaped screwdriver

PATTERNS (PROGRAMMED IN MACHINE)

22