Brother PC-2800 Metal bracket, For Keyhole Buttonholes, Eyelet punch 2 Basting pin

5

6

1

5

6

4.Lower the buttonhole lever so that it is positioned behind the metal bracket on the buttonhole foot.

1Metal bracket

5.Gently hold the end of the upper thread, and then start sew- ing. Feed the fabric carefully by hand while the buttonhole is sewn. Once sewing is completed, the machine automatically sews reinforcement stitches, and then stops.

Note

If the fabric does not feed (for example, because it is too thick), increase the stitch length setting.

CONTENTS

BEFORE USE

SEWING

UTILITY STITCHES

6.Insert a pin along the inside of one of the bar tacks, and then insert the seam ripper into the center of the buttonhole and cut towards the pin.

1Basting pin

CAUTION

When using the seam ripper to open the buttonhole, do not put your hand or finger in the path of the ripper. The ripper may slip and cause injury.

For Keyhole Buttonholes

Use the eyelet punch to make a hole in the rounded end of the buttonhole. Then insert a pin along the inside of one of the bar tacks, insert a seam ripper into the hole made with the eyelet punch, and cut towards the pin.

1Eyelet punch

2 Basting pin

PATTERNS MAINTENANCESEWING CHART(PROGRAMMED IN MACHINE)

43