Brother PC-2800 1 20 mm 3/4, Guide plate lower knife 2 Presser foot, Presser foot 3 Upper thread

1

	5
1 3	6
2	B
A

5

6

1

7. Make a cut of about 20 mm (3/4'') in the fabric.

120 mm (3/4'')

8.Place the fabric on foot as shown in figure B.

-Right side of cut: on top of the guide plate

-Left side of cut: underneath the presser foot

1Guide plate (lower knife)

2 Presser foot

9.Thread the needle, then pull out a long section of the upper thread, pass it below the presser foot and pull it out in the fabric feed direction (see figure B).

2Presser foot

3 Upper thread

CAUTION

If the width has been adjusted, turn the balance wheel by hand and check that the needle does not touch the side cutter. If the needle hits the side cutter, the needle may break and cause injury.

When Sewing Straight Stitches only

The seam margin should be about 5 mm (3/16'').

1Seam margin

*Make sure you select a pattern for the side cut- ter.

*Clean the side cutter after use, to avoid having dust and scraps of thread build up on it.

*Add a small amount of oil as required to the cutting edge of the cutter.

Note

–The fabric will not be cut if the whole fabric is simply spread out underneath the presser foot guide plate. Set the fabric as explained in step 8, and then start sewing.

–Check that the needle is raised when the presser foot lever is raised.

–One layer of 13 oz. denim can be cut.

CONTENTS

BEFORE USE

SEWING

PATTERNS UTILITY STITCHES MAINTENANCESEWING CHART(PROGRAMMED IN MACHINE)

39