Brother XL-6040 Removing the Material from the Machine, TOP Stitching and Stretch Materials

Models: XL-6040

1 101
Download 101 pages 18.3 Kb
Page 55
Image 55

1

STOFF AUS DER MASCHINE NEHMEN

1.Stoppen Sie die Maschine.

Heben Sie die Nadel auf die höchste Position und vergewissern Sie sich, daß der Fadenhebel sich ebenfalls auf höchster Position befindet.

2.Heben Sie den Nähfuß und ziehen Sie den Stoff vorsichtig nach links heraus.

3.Schneiden Sie beide Fäden mit dem Fadenabschneider links hinten an der Maschine ab.

1 Fadenabschneider

4.Zur Vorbereitung der Maschine für die nächste Naht ziehen Sie etwa 10 cm Faden durch den Schlitz des Nähfußes nach hinten heraus.

APPLIZIEREN UND STRETCH-MATERIALIEN

Der Geradstich wird für Obernähte und zum Nähen leichter Stoffe benutzt.

Der Stretch-Geradstich wird bei Stretch-Stoffen benutzt.

REMOVING THE MATERIAL FROM THE MACHINE

1.Stop the machine.

Raise the needle to its highest position and make sure that the thread take-up lever is also in its highest position.

2.Lift the presser foot and pull the fabric out gently to the left side.

3.Cut both threads with the thread cutter located on the left side of the machine.

1 Thread cutter

4.To prepare the machine for the next seam, pull about 10 cm (4") of thread through the toes of the presser foot toward the back of the machine.

TOP STITCHING AND STRETCH MATERIALS

Straight Stitch is used for top stitching and sewing lightweight fabrics.

Triple Stretch Stitch is used for stretch fabrics.

ZIGZAGSTITCHING

ZICKZACKSTICH

ЗИГЗАГООБРАЗНАЯСТРОЧКА

STRAIGHTAND

GERAD-UND

НОРМАЛЬНАЯПРЯМАЯИ

 

 

 

СНЯТИЕ ПРОШИТОЙ ТКАНИ С МАШИНЫ

1.Выключите машину.

Поднимите иглу в крайнее верхнее положение и убедитесь

втом, что рычаг подтягивания нитки при этом также находится в крайней верхней позиции.

2.Поднимите нажимную лапку и плавно отведите ткань влево из рабочей зоны иглы.

3.Обрежьте обе нитки с помощью ножа для обрезания ниток, расположенного в левой части машины.

1 Нож для обрезания ниток

4.Чтобы подготовить машину к выполнению следующей строчки, вытяните конец нитки через язычки нажимной лапки назад на длину около 10 см (4 дюйма) и, направив назад, расположите его позади лапки.

ВЕРХНИЙ СТЕЖОК И ЭЛАСТИЧНЫЕ МАТЕРИАЛЫ

Прямой стежок используется для верхних стежков и сшивания легких тканей.

Тройная трикотажная строчка используется для сшивания эластичных тканей.

44

Page 55
Image 55
Brother XL-6040 important safety instructions Removing the Material from the Machine, TOP Stitching and Stretch Materials