Brother XL-6040 Monogramming Embroidering, Preparing for Monogramming and Embroidering

ИСПОЛЬЗОВАНИЕПРИСПОСОБЛЕНИЙ ИИЗГОТОВЛЕНИЕ АППЛИКАЦИЙ HEFTENUND APPLIZIEREN USINGATTACHMENTS ANDAPPLICATIONS

69

A

Monogramming and

Embroidering

Pattern	Stitch Length	Stitch Width	Foot
(Zigzag Stitch)		Fixed 1.5
(Zigzag Stitch)	Any	Fixed 3.5	None
(Zigzag Stitch)		Fixed 5

PREPARING FOR MONOGRAMMING AND EMBROIDERING

1.Remove the power supply plug from the outlet. And place the darning plate on the needle plate as shown in fig. A. Connect the power supply plug into a wall outlet.

2.Set the Pattern Selection Dial to the appropriate Zigzag Stitch setting.

3.Draw the lettering (for monogramming) or design (for embroi- dering) on the surface of the fabric.

4.Stretch the fabric between embroidery hoops as firmly as possible with the underside of the fabric on the bottom of the inside hoop.

5.Place the work under the needle and lower the presser bar with the foot removed.

6.Pull the lower thread up through the work at the starting position by turning the balance wheel and make a few holding stitches.

7.Grip the hoop with the thumb and forefingers of both hands while pressing the fabric with the middle and third fingers and support- ing the outside of the hoop with your smaller fingers.

MONOGRAMMING

1.Sew, moving the hoop slowly along the lettering at a constant speed.

2.Secure with a few straight stitches at the end of the last letter.

EMBROIDERING

1.Stitch the outline of the design by moving the embroidery hoop.

2.Fill in the design alternating from the outline of the design to the inside and from the inside to the edge of the outline until the design is completely filled in. Keep the stitching close together.

NOTE:

A long stitch is made by moving the embroidery hoop rapidly and a short stitch is made by moving it slowly.

3. Secure with a few Straight Stitches at the end of the design.