Bunn S/N DUAL068000 manual READY TO BREW WATER TEMP 200º, Card Contains Recipe For

PROGRAMMING THE BREWER (cont.)

SET NEW RECIPES (cont.)

SET NEW RECIPE:

Using a RECIPE CARD to load coffee names and brew settings into the Dual SH DBC with Smart Funnel:

The G9-2T DBC or MHG's memory contains certain coffee names. If the operator uses a coffee name that is not already stored in the grinder's memory, a RECIPE CARD can be obtained from the factory. The RECIPE CARD would include all the information needed to set up that particular coffee name. The information from the RECIPE CARD is loaded into the grinder's memory, then into the brewer's memory by holding the chip area up to the equipment's sensing coil. This informa- tion can include the coffee name, BREW VOLUMES, BYPASS PERCENTAGES, PULSE BREW TIMES, and DRIP-OUT TIMES for that particular coffee NAME. These can all be loaded in seconds.

Contact Bunn-O-Matic Corporation for the avail- ability of RECIPE CARDS.

NOTE: Instructions to program the brewer and grinder are printed on the RECIPE CARD, along with the coffee name that is being programmed.

Procedure to program the coffee name:

1.Remove the funnels (if present) from the left and right funnel rails.

2.Position the RECIPE CARD vertically, so that the top end of the chip is beneath the left side funnel sensing coil.

3.After a short pause the display will read CARD CON- TAINS RECIPE FOR then will change to (COFFEE NAME) SHOW QUIT SAVE. All brewing parameters for that coffee name are now transferred from the CARD to the brewer.

4.To show (view) this information, press and release SHOW. The display will scroll through all of the brew settings for all three batch sizes. The display will then return to CARD CONTAINS RECIPE FOR then will change to (COFFEE NAME) SHOW QUIT SAVE.

5.If all brew settings are correct, press SAVE. The display will read (COFFEE NAME) SETUP COM- PLETE. All brew settings for that name are now stored in the brewer's memory.

6.If the brewing information is not correct, or it is desired to exit the setup before the settings are loaded into the brewer's memory, press QUIT. The display will read (COFFEE NAME) NOT SAVED. The display will then return to the MAIN SCREEN.

READY TO BREW

WATER TEMP: 200º

POSITION CARD UNDER THE

LEFT SIDE SENSOR COIL

CARD CONTAINS

RECIPE FOR

(COFFEE NAME) SHOW QUIT SAVE

SCROLLS THROUGH ALL		(COFFEE NAME)
OF THE BREW SETTINGS		SETUP COMPLETE
FOR THE THREE BATCH
SIZES FOR THAT COFFEE
NAME
(COFFEE NAME)
	NOT SAVED		P2300

Page 19 29877-3 062005