PROGRAMMING THE BREWER
The programming of the brewer is divided into two levels. There is one function in Level 1. All other functions are accessed in Level 2.
The following function screens are in order of appearance. Each screen will have instructions on how to access, and the procedures to program the various functions of the brewer.
IMPORTANT PROGRAMMING NOTES
- READ CAREFULLY -
To exit the programming mode at any time, press and release either ON/OFF switch located on the front switch panel. The display will return to the MAIN SCREEN.
If none of the five programming switches are pressed within one minute during the setup of the brewer, the programming of the function screen that is being set will be exited and the display will return to the MAIN
SCREEN.
Always remember to place a container and funnel under the sprayhead when operating the brewer during the
OUTPUTS.
PROGRAM FUNCTIONS - LEVEL 1
MAIN SCREEN
READY TO BREW WATER TEMP: 200°
BREW LOCKOUT
This function allows the operator to prevent or allow brewing if the water temperature is less than the set READY temperature.
To access this function screen press and hold the ® symbol. Release the ® when the display reads:
This screen will be shown when the brewer is ready for use. The screen displays the water temperature in the tank. When the water in the tank reaches the correct set temperature, the display will change from HEATING to READY TO BREW.
PROGRAMMING LOCKOUT SWITCH (mounted on main control board)
This switch can be set to prevent access to the programming levels of the brewer. Once all the cor- rect brew settings are programmed, the operator can set the switch to the "DISABLE" position to prohibit anyone from changing the settings.
| PROGRAM |
ENABLE | DISABLE |
PROGRAMMING
SWITCH
P2424
BREW LOCKOUT?
NO DONE YES
Press here | Press here | Press here |
for NO | for DONE | for YES |
The YES or NO should be flashing. Select YES to prevent brewing if the water temperature is below the set READY temperature. Select NO to permit brewing at any water temperature.
When finished, press and release DONE. This will exit this function screen and return to the MAIN SCREEN on the display.
Page 11 | |
|
