Bunn S/N DUAL068000 SET NEW RECIPE Using a Smart Funnel and a G9-2T DBC or MHG Grinder, No Name

PROGRAMMING THE BREWER (cont.)

SET NEW RECIPE

Using a Smart Funnel and a G9-2T DBC or MHG Grinder:

This function allows the operator to set BREW

VOLUMES, BYPASS PERCENTAGES, PULSE BREW TIMES, and DRIP-OUT TIMES for each coffee name preset in the grinder's memory.

Certain coffee NAMES are stored in the G9-2T DBC's memory. When a particular name of coffee is ground into the Smart Funnel, that name and the batch size selected are transferred from the grinder to the programming chip located in the funnel handle. The funnel is then inserted into the brewer's left side funnel rails. The sensor coil on the brewer reads the informa- tion contained in the handle. The name of the coffee flavor will then appear on the display. This then allows the operator to set the BREW VOLUMES, BYPASS PERCENTAGES, PULSE BREW TIMES, and DRIP-OUT TIMES for that particular coffee NAME. It also allows the operator to set other brewing parameters, such as BREW TEMPERATURE, READY TEMPERATURE, BREW LOCKOUTS, etc. Each coffee NAME can be set individually to provide optimum brewing quality.

SET NEW RECIPE?

NOYES

	INSERT FUNNEL
	WITH NEW NAME
	2 SEC.
	USE LEFT SIDE			CYCLES THROUGH
	ONLY			THREE SCREENS
	2 SEC.
	QUIT SETUP?
	YES
	FUNNEL DETECTED
	FUNNEL	FUNNEL CONTAINS
	CONTAINS NAME	NO NAME
(COFFEE NAME)		MUST GRIND INTO
NO	YES	FUNNEL FIRST
BEGIN SETUP OF
(COFFEE NAME)
SETUP BREW VOLUMES, BYPASS,			SEE SEPARATE DIAGRAMS
			FOR SETUP INSTRUCTIONS
PULSE BREW, PREINFUSION, DRIPOUT TIME
3 BATCHES DONE?
NO	YES
(COFFEE NAME)
SETUP COMPLETE
REVIEW RECIPES?
NO	YES			P2299

Procedure for Setting the Recipe:

NOTE: Before beginning setup, place a server beneath the left brew funnel.

1.Insert the funnel into the grinder and select a batch size to grind. It is not necessary to have coffee beans in the hopper(s) in order to program the brewer. The coffee name is pre-selected and stored in the grinder's memory for the side being ground.

2.Press the GRIND switch. When the grinder stops grinding, remove the funnel.

3.On the brewer, press and hold the upper right hidden switch (®) until the display reads UNITS. Release the switch, then press switch again until display reads SET NEW RECIPE.

4.Press and release YES. The display should read INSERT FUNNEL WITH NEW NAME, then USE LEFT SIDE ONLY, and finally, QUIT SETUP? These three displays will repeatedly cycle.

5.Insert the funnel into the rails on the left side of the brewer. The display should read the NAME of the coffee that was ground into the funnel, along with a NO and YES. If the NAME on the display is correct, press YES.

6.If, for some reason, the name of the coffee from the grinder did not load properly into the funnel, or if a grind has not yet been done, the display will read MUST GRIND INTO FUNNEL FIRST. It will be necessary to grind another batch following steps 1 and 2.

7.If the grind is acknowledged by the brewer, the display will read BEGIN SETUP OF (COFFEE NAME). Then the screen will display BREW OZ. and a batch light will be blinking. (Refer to BREW OZ (SETTING OR ADJUSTING for description)

BREW OZ. XX.X
(-)	DONE	(+)
3 BATCHES DONE?
NO		YES
% BYPASS XX.X
(-)	DONE	(+)

P2415

Page 17 29877-3 062005