Bunn S/N DUAL068000 manual Right, PROGRAMMING THE BREWER cont, SET NEW RECIPES cont SET NEW RECIPE

PROGRAMMING THE BREWER (cont.)

SET NEW RECIPES (cont.)

SET NEW RECIPE:

If not using a Smart Funnel (with a computer chip) and/or a G9-2T DBC or MHG Grinder, the brewer will function as a standard Bunn Dual Brewer:

It is possible to operate the brewer without using a Smart Funnel and/or a G9-2T DBC or MHG Grinder. If a standard funnel, or if a non-DBC grinder is used the brewer will automatically select a NO NAME coffee when the BREW switch is pressed. This means that no name was read from the funnel's handle.

There are two NO NAME coffee programs that can be set in the brewer. They are referred to as NO NAME LEFT and NO NAME RIGHT. The left and right sides of the brewer can be set up independently of each other. This includes BREW VOLUMES, BYPASS PERCENTAGES, PULSE BREW TIMES, and DRIP-OUT TIMES. The brewer will perform in the same capacity as a standard Bunn Dual Brewer.

The instructions for programming the NO NAME settings are on the following pages. The same steps are followed for setting the recipe as those that are used to MODIFY A RECIPE, beginning on page 21.

Note that when the display reads NO NAME LEFT, that is when MODIFY should be pressed in order to set the parameters for the NO NAME LEFT coffee.

Otherwise, press NEXT to display NO NAME

RIGHT.

At this point, MODIFY should be pressed in order to set the parameters for the NO NAME RIGHT coffee.

NOTE: Before beginning setup, insert a funnel into the left and right side funnel rails, and place a Soft Heat Server beneath each brew funnel.

REVIEW RECIPES?

NOYES

EXIT TO

NEXT FUNCTION

SCREEN

NO-NAME LEFT

MODIFYSHOWNEXT

BREW OZ. XX.X	NO-NAME RIGHT
(-) DONE (+)	MODIFYSHOWNEXT

BREW OZ. XX.X (-) DONE (+)

P2419

Page 20 29877-3 062005