Bunn S/N DUAL068000 ENTER TIMES? NOYES 1st ON TIME DONE + OFF TIMES DONE + LAST ON DONE +, Times?

PROGRAMMING THE BREWER (cont.)

SET PULSE BREW - ENTER TIMES

NOTE: The procedure to enter the PULSE BREW function must be performed prior to following the steps listed below.

1.Press and release YES. The display should now read EASY PULSE SETUP.

2.Press and release NO. The display will read ENTER

TIMES?

3.Press YES to proceed. The display should now read 1st ON TIME X:XX.

4.Using (-)and (+) set the amount of time the flow of water into the funnel will be on.

5.When finished, press DONE. The display will now read OFF TIMES: X:XX.

6.Using (-)and (+) set the amount of time the flow of water into the funnel will be off.

7.When finished, press DONE. The display will now read LAST ON: X.XX

8.Using (-)and (+) set the amount of time the water will be on to complete the brew.

9.When finished, press DONE. The display will show the three times just entered for that batch size. After a 5 second delay, the display will read 3 BATCHES

DONE?

10.If other batch sizes need to be modified, press

NO.

12.Press a different batch size and repeat steps 3 through 7. Repeat until all the desired batch sizes are set for the left side.

13.When finished press YES in 3 BATCHES DONE?. The display will then read DRIP TIME.

14.Press and release either of the ON/OFF switches located on the front switch panel to exit the SET PULSE BREW function and return to the MAIN

SCREEN.

NOTE: Pressing the upper right hidden button before reaching the final setting screen exits the setup and retains the old values.

Page 27

SET PULSE BREW?

NOYES

EASY PULSE SETUP

NOYES

EXIT TO

NEXT FUNCTION

SCREEN

ENTER TIMES?

NOYES

1st ON TIME X:XX

(-) DONE (+)

OFF TIMES: X:XX

(-) DONE (+)

LAST ON: X.XX

(-) DONE (+)

1st OFF LAST XX.X XX.X XX.X

5 SEC. DELAY

3 BATCHES DONE?

NO YES

EXIT TO

NEXT FUNCTION

SCREEN

P3265

29877-3 062005