Cabletron Systems SmartSwitch manual Ssrconfig# ppp apply service profile2 ports hs.5.1

Chapter 22: WAN Configuration Guide

Suppose you wish to set up a service profile called “profile2” that includes the following characteristics:

•Bridging enabled

•Leave high-, low-, and medium-priority queue depths set to factory defaults

•IP and IPX enabled

•Sending of LCP Echo Requests disabled

•Use of LCP magic numbers disabled

•The maximum allowable number of unanswered requests set to 8

•The maximum allowable number of negative-acknowledgment transmissions set to 5

•The maximum allowable number of unanswered/improperly answered connection- termination requests before declaring the link to a peer lost set to 4

•Random Early Discard disabled

•The number of seconds between subsequent configuration request transmissions (the “retry interval”) set to 25

•RMON enabled

The command line necessary to set up a service profile with the above attributes would be as follows:

ssr(config)# ppp define service profile2 bridging enable ip enable ipx enable lcp-echo off lcp-magic off max-configure 8 max-failure 5 max- terminate 4 red off retry-interval 25 rmon on

To assign the above service profile to the active PPP WAN port defined earlier (slot 5, port 1):

ssr(config)# ppp apply service profile2 ports hs.5.1

SmartSwitch Router User Reference Manual 331