Cabletron Systems SmartSwitch manual Deactivating the Line Card, Removing the Line Card

Chapter 2: Hot Swapping Line Cards and Control Modules

Deactivating the Line Card

To deactivate the line card, do one of the following:

•Press the Hot Swap button on the line card. The Hot Swap button is recessed in the line card's front panel. Use a pen or similar object to reach it.

When you press the Hot Swap button, the Offline LED lights. Figure 1 shows the location of the Offline LED and Hot Swap button on a 1000Base-SX line card.

Offline LED

SSR-GSX11-02						1000BASE-SX
Offline	Tx	Link	1	Tx	Link	2
						Hot
Online	Rx	AN		Rx	AN	Swap

Hot Swap Button

Figure 1. Location of Offline LED and Hot Swap button on a 1000Base-SX line card

•Use the system hotswap out command in the CLI. For example, to deactivate the line card in slot 7, enter the following command in Enable mode:

ssr# system hotswap out slot 7

After you enter this command, the Offline LED on the line card lights, and messages appear on the console indicating the ports on the line card are inoperative.

Note: If you have deactivated a line card and want to activate it again, simply pull it from its slot and push it back in again. (Make sure the Offline LED is lit before you pull out the line card.) The line card is activated automatically.

Alternately, if you have not removed a line card you deactivated with the system hotswap out command, you can reactivate it with the system hotswap in command. For example, to reactivate a line card in slot 7, enter the following command in Enable mode:

ssr# system hotswap in slot 7

Removing the Line Card

To remove a line card from the SSR:

1.Make sure the Offline LED on the line card is lit.

50 SmartSwitch Router User Reference Manual