Chapter 2: Hot Swapping Line Cards and Control Modules

Warning: You can only hot swap an inactive Control Module. You should never remove the active Control Module from the SSR. Doing so will crash the system.

The procedure for hot swapping a control module is similar to the procedure for hot swapping a line card. You must deactivate the Control Module, remove it from the SSR, and insert another Control Module or line card in the slot.

Deactivating the Control Module

To deactivate the Control Module:

1.Determine which is the secondary Control Module.

Control Modules can reside in slot CM or slot CM/1 on the SSR. Usually slot CM contains the primary Control Module, and slot CM/1 contains the secondary Control Module. On the primary Control Module, the Online LED is lit, and on the secondary Control Module, the Offline LED is lit.

Note: The Offline LED on the Control Module has a different function from the Offline LED on a line card. On a line card, it means that the line card has been deactivated. On a Control Module, a lit Offline LED means that it is standing by to take over as the primary Control Module if necessary; it does not mean that the Control Module has been deactivated.

2.Press the Hot Swap button on the secondary Control Module.

When you press the Hot Swap button, all the LEDs on the Control Module (including the Offline LED) are deactivated. Figure 2 shows the location of the Offline LED and Hot Swap button on a Control Module.

SSR-CM2

 

 

CONTROL MODULE

Console

10/100 Mgmt

 

Online Offline

RST SYS

OK HBT

 

 

Hot

 

 

 

 

 

ERR DIAG

Swap

 

 

 

Hot Swap Button

Offline LED

Figure 2. Location of Offline LED and Hot Swap button on a Control Module

Removing the Control Module

To remove a Control Module from the SSR:

1.Make sure that none of the LEDs on the Control Module are lit.

2.Loosen the captive screws on each side of the Control Module.

3.Carefully remove the Control Module from its slot in the SSR chassis.

52

SmartSwitch Router User Reference Manual

Page 52
Image 52
Cabletron Systems SmartSwitch manual Deactivating the Control Module, Removing the Control Module