Cabletron Systems SmartSwitch To RIP, Specify that RIP V2 packets, Should be multicast on this

Chapter 8: RIP Configuration Guide

RIP Parameter	Default Value
Authentication	None
Update interval	30 seconds

To change RIP parameters, enter the following commands in Configure mode.

Set RIP Version on an interface	rip set interface <interfacename-or-IPaddr>all
to RIP V1.	version 1
Set RIP Version on an interface	rip set interface <interfacename-or-IPaddr>all
to RIP V2.	version 2
Specify that RIP V2 packets	rip set interface <interfacename-or-IPaddr>all
should be multicast on this	type multicast
interface.
Specify that RIP V2 packets that	rip set interface <interfacename-or-IPaddr>all
are RIP V1-compatible should	type broadcast
be broadcast on this interface.
Change the metric on incoming	rip set interface <interfacename-or-IPaddr>all
RIP routes.	metric-in <num>
Change the metric on outgoing	rip set interface <interfacename-or-IPaddr>all
RIP routes.	metric-out <num>
Set the authentication method	rip set interface <interfacename-or-IPaddr>all
to simple text up to 8	authentication-method simple
characters.
Set the authentication method	rip set interface <interfacename-or-IPaddr>all
to MD5.	authentication-method md5
Specify the metric to be used	rip set default-metric <num>
when advertising routes that
were learned from other
protocols.
Enable automatic summari-	rip set auto-summary disableenable
zation and redistribution of RIP
routes.
Specify broadcast of RIP	rip set broadcast-state alwayschoosenever
packets regardless of number of
interfaces present.
Check that reserved fields in	rip set check-zero disableenable
incoming RIP V1 packets are
zero.

SmartSwitch Router User Reference Manual 111